Galletto 1260 is an easy hardware for auto chip tunning. It works on EDC16,EDC15, MEx.x ,DELCO and many more engine4s ecu. It is compatible with the newest modern diesel TDi, HDi, JTD, and petrol cars.
SMPS MPPS v12 Tuning Remap Chip tuning CAN Flasher is a USB chip tuning interface. This is good clone working with v12 version of software.This interface lets you to read and write memory of a car computer through the diagnostic connector.
BDM100 ECU chip tuning tool is a universal reader/programmer (it does not require our RACE software necessarily) that allows the user to read and program files in the ECU supplied with MOTOROLA MPC5xx processor (essential).
912 9S12 Programmer For Motorola
The MC68HC908AZ60 programmer supports Motorola MC68HC(9)08AZxx/ASxx, MC68HC05H12 microcontrollers internal EEPROM and FLASH reading, programming. This MCU most used in automotive computers (dashboards, AIRBAG, immobilizers).
KWP 2000 Plus ECU REMAP Flasher Tuning Tool can read and analyze current ECU software,upgrade the ECU software with a re-mapped file,and repair ECUS with software problems or corruption.
D80D0WQ ERASER/Programmer was used to Read, Program, Erase Incremental Registers\EEPROM. Compatible with Windwos 98/2000/XP
MC68HC11 Programmer communication with PC via a serial port ,it is easy to use Windows 98/ME/XP software In-circuit/On-board.
The MC68HC705B16 programmer supports programming of Motorola 68HC05Bxx, 68HC05Xxx microcontrollers internal EEPROM - most used programmable device in car radios, automotive computers (dashboards, AIRBAG, immobilizers).
Audi VW micronas /Fujitsu programmer 2.0 >R200+R250
Audi VW micronas/Fujitsu programmer 2.0 replace the R200 and R250 fully
MCU controlled Interface for Mercedes Benz Carsoft 7.4 brand new.
1.You can read/erase all fault codes with this device,
2.also can read ecu information.
KWP 2000 Plus ECU REMAP Flasher Tuning Tool
With this tool,you can ：
1. Read and analys your current ECU software;
2.Upgrad the ECU software with a re-mapped file ;
3.Repair ECUs with software problems or corruption
The XPROG-m programmer is the upgrated version of XPROG programmer. XPROG-m programmer is fully upward-compatible hardware with XPROG programmer and have many additional features.
New version release: V5.0
This CMD CAN Flasher V1251 read and write flash memory via the diagnostic connector on the CAN line of computers with motor MED9.1, MED9.5, EDC16U3x/CP, EDC16CP31, EDC16CP36, EDC16C3 and EDC16C9 fuel injection. Working through CAN, not on K line.
1. Truck version KESS V2, support more trucks model than any version.
2. Compared with other version, firmware V4.024 is more stable.